Nanolex Si3D Matte Paint Protection Kit
|Warehouse - For Delivery||Yes||In Stock|
|Sydney - Store Pickup||No||Out Of Stock|
|Brisbane - Store Pickup||No||In Stock|
|Melbourne - Store Pickup||No||In Stock|
|Perth - Store Pickup||No||In Stock|
Nanolex Si3D Matte is an advanced silica-based coating formulated specifically to protect matt paint finishes and matt vinyl wraps without adding any gloss or otherwise altering their appearance. Developed in Germany, it uses the latest in low volatile content silicon (Si) technology to lay down a film of hybrid siloxane polymers and proprietary thermoplastic components that condenses rapidly to form a flexible matrix-like coating that bonds to treated surfaces at the molecular level. As a result, it provides excellent protection against bird droppings, bug splatter, brake dust, road salt and harmful UV radiation from the sun for up to two years at a time, even on daily drivers (it is impervious to cleaning chemicals and pressure washing).
However, the benefits imparted by Nanolex Si3D Matte do not end with outstanding levels of protection and durability. Perhaps equally as importantly, treated surfaces become slicker feeling and more hydrophobic. This latter characteristic not only results in impressive beading upon contact with water, but also produces a strong self-cleaning effect (rainfall beads up and rolls off of treated surfaces, taking freshly deposited contaminants with it, akin to the Lotus Effect in nature). This results in treated bodywork staying appreciably cleaner for longer between routine washes, particularly in the winter.
You should apply Nanolex Si3D Matte in a warm, dry, well-ventilated space out of direct sunlight. For your comfort and protection, we recommend wearing Nitrile Gloves and a Face Respirator during the application process. In all cases, prepare the matt surfaces you are going to treat in the normal way (wash > decontaminate), and then do a wipe down with Nanolex EX to ensure that they are spotlessly clean. Next, using a Nanolex Si3D Applicator Towel wrapped around a Nanolex Si3D Applicator Block, spread a thick layer of Nanolex Si3D Matte on to the first 18" x 18" section of bodywork, using light pressure and overlapping strokes. Then, continue spreading the product in a criss-cross fashion until it completely disappears. Next, finish the levelling process by buffing the treated section with a Nanolex Microfiber Buffing Towel. Finally, using a bright light, check the section carefully for any smears and remove them before moving on; failure to remove smears fully can result in them hardening to the point of being impossible to remove, so make sure you are thorough!
After all of the bodywork is treated the car must then be left in a warm, dry place out of direct sunlight for a minimum of 12 hours to allow the coating to harden (if you wish, you can accelerate this process by heating the treated panels to 60°C for 10 minutes using an infra-red heat lamp). Note that in order for the coating to harden properly it must remain completely dry during this period, and you should also avoid washing the car with any kind of detergent for the first 3 days afterwards. Please note that you must discard all used applicator towels and buffing towels after each application, because Nanolex Si3D Matte hardens massively as it cures, forming a residue that has the potential to inflict severe marring or worse if applicators and towels are re-used. Please also note that the quoted shelf life of Nanolex Si3D Matte is between 3-6 weeks once the bottle is opened, although this can be extended to 2-3 months if it is stored in a refrigerator.